Plotting Layers

[Peter]

When plotting, CAD Viewer does not seem to recognise layers marked within AutoCAD as not to be plotted. Is this correct?

I know that it can be controlled via the "Layer.ini" file but believed it would be part of this new version.

Also within the Layer manager dialog window there appears two additional layers prefix as "P_S_"

One is P_S_0 and the other is P_S_Nonplot which is the layer we normally do not wished ploted. Where do these layers come from and what is their use.

[GuthCAD Software Support]

Peter,

When plotting, CAD Viewer does not seem to recognise layers marked within AutoCAD as not to be plotted. Is this correct?Yes, it is correct. It should be in the new version as you say, and we will try and get this rectified ASAP - hopefully in a software update in about 1 week. We will post a notification to this thread when it is ready!

The P_S_ prefixed layers are added as working layers by CAD Viewer. I am not sure that they are needed anymore, and will we investigate and hopefully remove them.

best regards
Software Support