Arcview 2 CAD Error

[newberry@wadeinc.com]

Arcview to Cad ver 3.2 critical error 2, ad error 209 (error allocating btree buffer), terminating.

Why would I get the above error?

[GuthCAD Software Support]

Hi,

Basically it is an error saying that there was not enough memory to perform the operation.

A couple of possible causes:

1. There is not enough memory to perform the operation. Suspect if the file is larger than normal.
2. It is a side effect caused by an unrelated software error. Suspect if the file is not large.

Possible Solutions:

1. Try Arcv2CAD 4.0 to see if the problem still occurs.

http://www.guthcad.com/download.htm

2. Select output to be AutoCAD Release 14 DXF (which uses less memory.)

regards,
Software Support